METAL BRITE HD 25 LTR

Unitor™ Metal Brite H.D™ is a non-flammable rust and metal tarnish remover. It is highly concentrated and very economical in use.

Specification

Approvals

• This composition meets the criteria for not being harmful to the marine environment according to MARPOL Annex V and may be discharged into the sea when used to clean cargo holds and external surfaces on ships.
• Approved by the Norwegian Institute of Public Health for use as cleaner of tanks in contact with cooking oil.

Safety Data Sheet (SDS)

Documents

•  (PDF)SDoC and MD for IHM

Directions for use

Dosing method
Unitor™ Metal Brite H.D. should always be used in a plastic bucket. Acid should always be added to water, never the reverse. Remove dirt, rust flakes, oil and grease prior to using Unitor™ Metal Brite H.D.

Apply Unitor™ Metal Brite H.D. to surfaces to be cleaned or pickled as follows:

For severely corroded surfaces and pickling of welding repairs, use 50% solution to neat.

For less severely corroded or soiled surfaces and tarnish on copper and brass, use a solution of 20–50%, and rinse off surface after 15–40 minutes with water.

On aluminium, use a solution of 10–30%, but rinse off surface maximum 5 minutes after application.

For removal of rust stains on painted surfaces, a solution of 10–30% should be sufficient. Rinse off with water 15–20 minutes after application.

For removal of rust stains on ceramic tiles, enamels, porcelain, glass etc., use a solution of 20–50%, depending on stains and soiling. Rinse off with water after 20–40 minutes.

For removal of light cement stains and lime, apply a 50% solution, and high pressure wash after 30–40 minutes, and for solidified cement use Unitor™ Descaling Liquid.

For removal of light rust and scale in pipelines and tanks, recirculate a solution of 5–10% Unitor™ Metal Brite H.D. For discoloration of stainless steel and epoxy coated tanks use the same method.

For removal of white residues from epoxy-coatings that sometimes remains after carriage of Stearin, Olein, Palm fatty acid etc., recirculate a solution of 5–10% Unitor™ Metal Brite H.D. When injected, use a 5% solution. Recirculate or inject until residue is removed.